xref: /kernel/linux/linux-6.6/Documentation/devicetree/bindings/spi/st,stm32-spi.yaml

# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/spi/st,stm32-spi.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: STMicroelectronics STM32 SPI Controller

description: |
  The STM32 SPI controller is used to communicate with external devices using
  the Serial Peripheral Interface. It supports full-duplex, half-duplex and
  simplex synchronous serial communication with external devices. It supports
  from 4 to 32-bit data size.

maintainers:
  - Erwan Leray <erwan.leray@foss.st.com>
  - Fabrice Gasnier <fabrice.gasnier@foss.st.com>

allOf:
  - $ref: spi-controller.yaml#
  - if:
      properties:
        compatible:
          contains:
            const: st,stm32f4-spi

    then:
      properties:
        st,spi-midi-ns: false

properties:
  compatible:
    enum:
      - st,stm32f4-spi
      - st,stm32h7-spi

  reg:
    maxItems: 1

  clocks:
    maxItems: 1

  interrupts:
    maxItems: 1

  resets:
    maxItems: 1

  dmas:
    description: |
      DMA specifiers for tx and rx dma. DMA fifo mode must be used. See
      the STM32 DMA bindings Documentation/devicetree/bindings/dma/st,stm32-dma.yaml.
    items:
      - description: rx DMA channel
      - description: tx DMA channel

  dma-names:
    items:
      - const: rx
      - const: tx

patternProperties:
  "^[a-zA-Z][a-zA-Z0-9,+\\-._]{0,63}@[0-9a-f]+$":
    type: object
    # SPI slave nodes must be children of the SPI master node and can
    # contain the following properties.
    properties:
      st,spi-midi-ns:
        description: |
          Only for STM32H7, (Master Inter-Data Idleness) minimum time
          delay in nanoseconds inserted between two consecutive data frames.

required:
  - compatible
  - reg
  - clocks
  - interrupts

unevaluatedProperties: false

examples:
  - |
    #include <dt-bindings/interrupt-controller/arm-gic.h>
    #include <dt-bindings/clock/stm32mp1-clks.h>
    #include <dt-bindings/reset/stm32mp1-resets.h>
    spi@4000b000 {
        #address-cells = <1>;
        #size-cells = <0>;
        compatible = "st,stm32h7-spi";
        reg = <0x4000b000 0x400>;
        interrupts = <GIC_SPI 36 IRQ_TYPE_LEVEL_HIGH>;
        clocks = <&rcc SPI2_K>;
        resets = <&rcc SPI2_R>;
        dmas = <&dmamux1 0 39 0x400 0x05>,
               <&dmamux1 1 40 0x400 0x05>;
        dma-names = "rx", "tx";
        cs-gpios = <&gpioa 11 0>;
    };

...