xref: /kernel/linux/linux-6.6/Documentation/devicetree/bindings/ata/ahci-mtk.txt (revision 62306a36)

MediaTek Serial ATA controller

Required properties:
 - compatible	   : Must be "mediatek,<chip>-ahci", "mediatek,mtk-ahci".
		     When using "mediatek,mtk-ahci" compatible strings, you
		     need SoC specific ones in addition, one of:
		     - "mediatek,mt7622-ahci"
 - reg		   : Physical base addresses and length of register sets.
 - interrupts	   : Interrupt associated with the SATA device.
 - interrupt-names : Associated name must be: "hostc".
 - clocks	   : A list of phandle and clock specifier pairs, one for each
		     entry in clock-names.
 - clock-names	   : Associated names must be: "ahb", "axi", "asic", "rbc", "pm".
 - phys		   : A phandle and PHY specifier pair for the PHY port.
 - phy-names	   : Associated name must be: "sata-phy".
 - ports-implemented : See ./ahci-platform.txt for details.

Optional properties:
 - power-domains   : A phandle and power domain specifier pair to the power
		     domain which is responsible for collapsing and restoring
		     power to the peripheral.
 - resets	   : Must contain an entry for each entry in reset-names.
		     See ../reset/reset.txt for details.
 - reset-names	   : Associated names must be: "axi", "sw", "reg".
 - mediatek,phy-mode : A phandle to the system controller, used to enable
		       SATA function.

Example:

	sata: sata@1a200000 {
		compatible = "mediatek,mt7622-ahci",
			     "mediatek,mtk-ahci";
		reg = <0 0x1a200000 0 0x1100>;
		interrupts = <GIC_SPI 233 IRQ_TYPE_LEVEL_HIGH>;
		interrupt-names = "hostc";
		clocks = <&pciesys CLK_SATA_AHB_EN>,
			 <&pciesys CLK_SATA_AXI_EN>,
			 <&pciesys CLK_SATA_ASIC_EN>,
			 <&pciesys CLK_SATA_RBC_EN>,
			 <&pciesys CLK_SATA_PM_EN>;
		clock-names = "ahb", "axi", "asic", "rbc", "pm";
		phys = <&u3port1 PHY_TYPE_SATA>;
		phy-names = "sata-phy";
		ports-implemented = <0x1>;
		power-domains = <&scpsys MT7622_POWER_DOMAIN_HIF0>;
		resets = <&pciesys MT7622_SATA_AXI_BUS_RST>,
			 <&pciesys MT7622_SATA_PHY_SW_RST>,
			 <&pciesys MT7622_SATA_PHY_REG_RST>;
		reset-names = "axi", "sw", "reg";
		mediatek,phy-mode = <&pciesys>;
	};