1// SPDX-License-Identifier: GPL-2.0-only
2/*
3 *
4 *  Copyright © 2012 John Crispin <john@phrozen.org>
5 *  Copyright © 2016 Hauke Mehrtens <hauke@hauke-m.de>
6 */
7
8#include <linux/mtd/rawnand.h>
9#include <linux/of_gpio.h>
10#include <linux/of_platform.h>
11
12#include <lantiq_soc.h>
13
14/* nand registers */
15#define EBU_ADDSEL1		0x24
16#define EBU_NAND_CON		0xB0
17#define EBU_NAND_WAIT		0xB4
18#define  NAND_WAIT_RD		BIT(0) /* NAND flash status output */
19#define  NAND_WAIT_WR_C		BIT(3) /* NAND Write/Read complete */
20#define EBU_NAND_ECC0		0xB8
21#define EBU_NAND_ECC_AC		0xBC
22
23/*
24 * nand commands
25 * The pins of the NAND chip are selected based on the address bits of the
26 * "register" read and write. There are no special registers, but an
27 * address range and the lower address bits are used to activate the
28 * correct line. For example when the bit (1 << 2) is set in the address
29 * the ALE pin will be activated.
30 */
31#define NAND_CMD_ALE		BIT(2) /* address latch enable */
32#define NAND_CMD_CLE		BIT(3) /* command latch enable */
33#define NAND_CMD_CS		BIT(4) /* chip select */
34#define NAND_CMD_SE		BIT(5) /* spare area access latch */
35#define NAND_CMD_WP		BIT(6) /* write protect */
36#define NAND_WRITE_CMD		(NAND_CMD_CS | NAND_CMD_CLE)
37#define NAND_WRITE_ADDR		(NAND_CMD_CS | NAND_CMD_ALE)
38#define NAND_WRITE_DATA		(NAND_CMD_CS)
39#define NAND_READ_DATA		(NAND_CMD_CS)
40
41/* we need to tel the ebu which addr we mapped the nand to */
42#define ADDSEL1_MASK(x)		(x << 4)
43#define ADDSEL1_REGEN		1
44
45/* we need to tell the EBU that we have nand attached and set it up properly */
46#define BUSCON1_SETUP		(1 << 22)
47#define BUSCON1_BCGEN_RES	(0x3 << 12)
48#define BUSCON1_WAITWRC2	(2 << 8)
49#define BUSCON1_WAITRDC2	(2 << 6)
50#define BUSCON1_HOLDC1		(1 << 4)
51#define BUSCON1_RECOVC1		(1 << 2)
52#define BUSCON1_CMULT4		1
53
54#define NAND_CON_CE		(1 << 20)
55#define NAND_CON_OUT_CS1	(1 << 10)
56#define NAND_CON_IN_CS1		(1 << 8)
57#define NAND_CON_PRE_P		(1 << 7)
58#define NAND_CON_WP_P		(1 << 6)
59#define NAND_CON_SE_P		(1 << 5)
60#define NAND_CON_CS_P		(1 << 4)
61#define NAND_CON_CSMUX		(1 << 1)
62#define NAND_CON_NANDM		1
63
64struct xway_nand_data {
65	struct nand_controller	controller;
66	struct nand_chip	chip;
67	unsigned long		csflags;
68	void __iomem		*nandaddr;
69};
70
71static u8 xway_readb(struct mtd_info *mtd, int op)
72{
73	struct nand_chip *chip = mtd_to_nand(mtd);
74	struct xway_nand_data *data = nand_get_controller_data(chip);
75
76	return readb(data->nandaddr + op);
77}
78
79static void xway_writeb(struct mtd_info *mtd, int op, u8 value)
80{
81	struct nand_chip *chip = mtd_to_nand(mtd);
82	struct xway_nand_data *data = nand_get_controller_data(chip);
83
84	writeb(value, data->nandaddr + op);
85}
86
87static void xway_select_chip(struct nand_chip *chip, int select)
88{
89	struct xway_nand_data *data = nand_get_controller_data(chip);
90
91	switch (select) {
92	case -1:
93		ltq_ebu_w32_mask(NAND_CON_CE, 0, EBU_NAND_CON);
94		ltq_ebu_w32_mask(NAND_CON_NANDM, 0, EBU_NAND_CON);
95		spin_unlock_irqrestore(&ebu_lock, data->csflags);
96		break;
97	case 0:
98		spin_lock_irqsave(&ebu_lock, data->csflags);
99		ltq_ebu_w32_mask(0, NAND_CON_NANDM, EBU_NAND_CON);
100		ltq_ebu_w32_mask(0, NAND_CON_CE, EBU_NAND_CON);
101		break;
102	default:
103		BUG();
104	}
105}
106
107static void xway_cmd_ctrl(struct nand_chip *chip, int cmd, unsigned int ctrl)
108{
109	struct mtd_info *mtd = nand_to_mtd(chip);
110
111	if (cmd == NAND_CMD_NONE)
112		return;
113
114	if (ctrl & NAND_CLE)
115		xway_writeb(mtd, NAND_WRITE_CMD, cmd);
116	else if (ctrl & NAND_ALE)
117		xway_writeb(mtd, NAND_WRITE_ADDR, cmd);
118
119	while ((ltq_ebu_r32(EBU_NAND_WAIT) & NAND_WAIT_WR_C) == 0)
120		;
121}
122
123static int xway_dev_ready(struct nand_chip *chip)
124{
125	return ltq_ebu_r32(EBU_NAND_WAIT) & NAND_WAIT_RD;
126}
127
128static unsigned char xway_read_byte(struct nand_chip *chip)
129{
130	return xway_readb(nand_to_mtd(chip), NAND_READ_DATA);
131}
132
133static void xway_read_buf(struct nand_chip *chip, u_char *buf, int len)
134{
135	int i;
136
137	for (i = 0; i < len; i++)
138		buf[i] = xway_readb(nand_to_mtd(chip), NAND_WRITE_DATA);
139}
140
141static void xway_write_buf(struct nand_chip *chip, const u_char *buf, int len)
142{
143	int i;
144
145	for (i = 0; i < len; i++)
146		xway_writeb(nand_to_mtd(chip), NAND_WRITE_DATA, buf[i]);
147}
148
149static int xway_attach_chip(struct nand_chip *chip)
150{
151	if (chip->ecc.engine_type == NAND_ECC_ENGINE_TYPE_SOFT &&
152	    chip->ecc.algo == NAND_ECC_ALGO_UNKNOWN)
153		chip->ecc.algo = NAND_ECC_ALGO_HAMMING;
154
155	return 0;
156}
157
158static const struct nand_controller_ops xway_nand_ops = {
159	.attach_chip = xway_attach_chip,
160};
161
162/*
163 * Probe for the NAND device.
164 */
165static int xway_nand_probe(struct platform_device *pdev)
166{
167	struct xway_nand_data *data;
168	struct mtd_info *mtd;
169	struct resource *res;
170	int err;
171	u32 cs;
172	u32 cs_flag = 0;
173
174	/* Allocate memory for the device structure (and zero it) */
175	data = devm_kzalloc(&pdev->dev, sizeof(struct xway_nand_data),
176			    GFP_KERNEL);
177	if (!data)
178		return -ENOMEM;
179
180	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
181	data->nandaddr = devm_ioremap_resource(&pdev->dev, res);
182	if (IS_ERR(data->nandaddr))
183		return PTR_ERR(data->nandaddr);
184
185	nand_set_flash_node(&data->chip, pdev->dev.of_node);
186	mtd = nand_to_mtd(&data->chip);
187	mtd->dev.parent = &pdev->dev;
188
189	data->chip.legacy.cmd_ctrl = xway_cmd_ctrl;
190	data->chip.legacy.dev_ready = xway_dev_ready;
191	data->chip.legacy.select_chip = xway_select_chip;
192	data->chip.legacy.write_buf = xway_write_buf;
193	data->chip.legacy.read_buf = xway_read_buf;
194	data->chip.legacy.read_byte = xway_read_byte;
195	data->chip.legacy.chip_delay = 30;
196
197	nand_controller_init(&data->controller);
198	data->controller.ops = &xway_nand_ops;
199	data->chip.controller = &data->controller;
200
201	platform_set_drvdata(pdev, data);
202	nand_set_controller_data(&data->chip, data);
203
204	/* load our CS from the DT. Either we find a valid 1 or default to 0 */
205	err = of_property_read_u32(pdev->dev.of_node, "lantiq,cs", &cs);
206	if (!err && cs == 1)
207		cs_flag = NAND_CON_IN_CS1 | NAND_CON_OUT_CS1;
208
209	/* setup the EBU to run in NAND mode on our base addr */
210	ltq_ebu_w32(CPHYSADDR(data->nandaddr)
211		    | ADDSEL1_MASK(3) | ADDSEL1_REGEN, EBU_ADDSEL1);
212
213	ltq_ebu_w32(BUSCON1_SETUP | BUSCON1_BCGEN_RES | BUSCON1_WAITWRC2
214		    | BUSCON1_WAITRDC2 | BUSCON1_HOLDC1 | BUSCON1_RECOVC1
215		    | BUSCON1_CMULT4, LTQ_EBU_BUSCON1);
216
217	ltq_ebu_w32(NAND_CON_NANDM | NAND_CON_CSMUX | NAND_CON_CS_P
218		    | NAND_CON_SE_P | NAND_CON_WP_P | NAND_CON_PRE_P
219		    | cs_flag, EBU_NAND_CON);
220
221	/*
222	 * This driver assumes that the default ECC engine should be TYPE_SOFT.
223	 * Set ->engine_type before registering the NAND devices in order to
224	 * provide a driver specific default value.
225	 */
226	data->chip.ecc.engine_type = NAND_ECC_ENGINE_TYPE_SOFT;
227
228	/* Scan to find existence of the device */
229	err = nand_scan(&data->chip, 1);
230	if (err)
231		return err;
232
233	err = mtd_device_register(mtd, NULL, 0);
234	if (err)
235		nand_cleanup(&data->chip);
236
237	return err;
238}
239
240/*
241 * Remove a NAND device.
242 */
243static int xway_nand_remove(struct platform_device *pdev)
244{
245	struct xway_nand_data *data = platform_get_drvdata(pdev);
246	struct nand_chip *chip = &data->chip;
247	int ret;
248
249	ret = mtd_device_unregister(nand_to_mtd(chip));
250	WARN_ON(ret);
251	nand_cleanup(chip);
252
253	return 0;
254}
255
256static const struct of_device_id xway_nand_match[] = {
257	{ .compatible = "lantiq,nand-xway" },
258	{},
259};
260
261static struct platform_driver xway_nand_driver = {
262	.probe	= xway_nand_probe,
263	.remove	= xway_nand_remove,
264	.driver	= {
265		.name		= "lantiq,nand-xway",
266		.of_match_table = xway_nand_match,
267	},
268};
269
270builtin_platform_driver(xway_nand_driver);
271