xref: /kernel/linux/linux-5.10/Documentation/devicetree/bindings/clock/rockchip,rk3368-cru.txt

* Rockchip RK3368 Clock and Reset Unit

The RK3368 clock controller generates and supplies clock to various
controllers within the SoC and also implements a reset controller for SoC
peripherals.

Required Properties:

- compatible: should be "rockchip,rk3368-cru"
- reg: physical base address of the controller and length of memory mapped
  region.
- #clock-cells: should be 1.
- #reset-cells: should be 1.

Optional Properties:

- rockchip,grf: phandle to the syscon managing the "general register files"
  If missing, pll rates are not changeable, due to the missing pll lock status.

Each clock is assigned an identifier and client nodes can use this identifier
to specify the clock which they consume. All available clocks are defined as
preprocessor macros in the dt-bindings/clock/rk3368-cru.h headers and can be
used in device tree sources. Similar macros exist for the reset sources in
these files.

External clocks:

There are several clocks that are generated outside the SoC. It is expected
that they are defined using standard clock bindings with following
clock-output-names:
 - "xin24m" - crystal input - required,
 - "xin32k" - rtc clock - optional,
 - "ext_i2s" - external I2S clock - optional,
 - "ext_gmac" - external GMAC clock - optional
 - "ext_hsadc" - external HSADC clock - optional,
 - "ext_isp" - external ISP clock - optional,
 - "ext_jtag" - external JTAG clock - optional
 - "ext_vip" - external VIP clock - optional,
 - "usbotg_out" - output clock of the pll in the otg phy

Example: Clock controller node:

	cru: clock-controller@ff760000 {
		compatible = "rockchip,rk3368-cru";
		reg = <0x0 0xff760000 0x0 0x1000>;
		rockchip,grf = <&grf>;
		#clock-cells = <1>;
		#reset-cells = <1>;
	};

Example: UART controller node that consumes the clock generated by the clock
  controller:

	uart0: serial@10124000 {
		compatible = "snps,dw-apb-uart";
		reg = <0x10124000 0x400>;
		interrupts = <GIC_SPI 34 IRQ_TYPE_LEVEL_HIGH>;
		reg-shift = <2>;
		reg-io-width = <1>;
		clocks = <&cru SCLK_UART0>;
	};