umax.c - OpenGrok cross reference for /third_party/backends/backend/umax.c

Lines Matching defs:DBG_sense
85 #define DBG_sense   2
331   if (flag != 0) { DBG(DBG_sense,"%s", text); }
886   DBG(DBG_sense, "check condition sense: %s\n", sense_str[sensekey]);
899       DBG(DBG_sense, "-> %s (#%d)\n", scanner_error_str[scanner_error], scanner_error);
903       DBG(DBG_sense, "-> error %d\n", scanner_error);
909     DBG(DBG_sense, "-> ILI-ERROR: requested data length is larger than actual length\n");
922         DBG(DBG_sense, "-> misfeed, paper jam\n");
927         DBG(DBG_sense, "-> adf not ready\n");
932         DBG(DBG_sense, "-> unknown medium error: asc=%d, ascq=%d\n", asc, ascq);
940         DBG(DBG_sense, "-> diagnostic error:\n");
960         DBG(DBG_sense, "-> unknown hardware error: asc=%d, ascq=%d\n", asc, ascq);
969         DBG(DBG_sense, "-> invalid command operation code\n");
973         DBG(DBG_sense, "-> illegal field in CDB\n");
977         DBG(DBG_sense, "-> logical unit not supported\n");
981         DBG(DBG_sense, "-> invalid field in parameter list\n");
985         DBG(DBG_sense, "-> too many windows specified\n");
989         DBG(DBG_sense, "-> invalid combination of windows specified\n");
993         DBG(DBG_sense, "-> illegal request: asc=%d, ascq=%d\n", asc, ascq);
1002             DBG(DBG_sense, "-> illegal parameter in CDB\n");
1006             DBG(DBG_sense, "-> illegal parameter is in the data parameters sent during data out phase\n");
1009           DBG(DBG_sense, "-> error detected in byte %d\n", get_RS_field_pointer(result));
1019         DBG(DBG_sense, "-> power on, reset or bus device reset\n");
1023         DBG(DBG_sense, "-> microcode has been changed\n");
1027         DBG(DBG_sense, "-> unit attention: asc=%d, ascq=%d\n", asc, ascq);
1036         DBG(DBG_sense, "-> button protocol\n");
1040           DBG(DBG_sense, "-> button 0 pressed\n");
1046           DBG(DBG_sense, "-> button 1 pressed\n");
1052           DBG(DBG_sense, "-> button 2 pressed\n");
1058         DBG(DBG_sense, "-> lamp warmup\n");
1063         DBG(DBG_sense, "-> calibration by driver\n");
1072         DBG(DBG_sense, "-> vendor specific sense-code: asc=%d, ascq=%d\n", asc, ascq);