Lines Matching defs:ERROR_MESSAGE
125 #define ERROR_MESSAGE 1
215 DBG (ERROR_MESSAGE, "wait_ready: test unit ready failed (%s)\n",
222 DBG (ERROR_MESSAGE, "wait_ready: timed out after %ld seconds\n",
248 DBG (ERROR_MESSAGE, "Sense: Scanner not ready\n");
251 DBG (ERROR_MESSAGE, "Sense: Hardware Error. Read more...\n");
254 DBG (ERROR_MESSAGE, "Sense: Illegal request\n");
257 DBG (ERROR_MESSAGE, "Sense: Unit Attention (Wait until scanner "
261 DBG (ERROR_MESSAGE, "Sense: Vendor Unique. Read more...\n");
264 DBG (ERROR_MESSAGE, "Sense: Unknown Sense Key. Read more...\n");
288 DBG (ERROR_MESSAGE, "Additional Length %u\n", (unsigned int) result[7]);
301 DBG (ERROR_MESSAGE, "Sense: Dim Light (output of lamp below 70%%).\n");
304 DBG (ERROR_MESSAGE, "Sense: No Light at all.\n");
307 DBG (ERROR_MESSAGE, "Sense: No Home.\n");
310 DBG (ERROR_MESSAGE, "Sense: No Limit. Tried to scan out of range.\n");
360 DBG (ERROR_MESSAGE, "Can't match mode %s\n", s->val[OPT_MODE].s);
376 DBG (ERROR_MESSAGE, "Can't match haftone pattern %s\n",
427 DBG (ERROR_MESSAGE, "attach: open failed (%s)\n",
440 DBG (ERROR_MESSAGE, "attach: inquiry failed (%s)\n",
460 DBG (ERROR_MESSAGE, "attach: device doesn't look like an Abaton scanner "
532 DBG (ERROR_MESSAGE, "calc_parameters: Invalid mode %s\n", (char *) val);
608 DBG (ERROR_MESSAGE, "Invalid mode %s\n", (char *) val);
999 DBG (ERROR_MESSAGE, "close: invalid handle %p\n", handle);
1226 DBG (ERROR_MESSAGE, "open: open of %s failed: %s\n",
1235 DBG (ERROR_MESSAGE, "open: wait_ready() failed: %s\n",
1243 DBG (ERROR_MESSAGE, "sane_start: request_sense revealed error: %s\n",
1251 DBG (ERROR_MESSAGE, "open: set scan area command failed: %s\n",
1323 DBG (ERROR_MESSAGE, "sane_read: cannot get_data_status.\n");
1395 DBG (ERROR_MESSAGE, "sane_read: request_sense revealed error: %s\n",