Lines Matching defs:power
322 * @BSS_CHANGED_TXPOWER: TX power setting changed for this interface
602 * @txpower: TX power in dBm. INT_MIN means not configured.
603 * @txpower_type: TX power adjustment used to control per packet Transmit
640 * @power_type: power type of BSS for 6 GHz
641 * @tx_pwr_env: transmit power envelope array of BSS.
643 * @pwr_reduction: power constraint of BSS.
1234 * dynamic way to report about used rates and power levels per packet.
1239 * corresponding wifi hardware. The idx shall point to the power level
1600 * @IEEE80211_CONF_PS: Enable 802.11 power save mode (managed mode only).
1601 * This is the power save mode defined by IEEE 802.11-2007 section 11.2,
1629 * @IEEE80211_CONF_CHANGE_POWER: the TX power changed
1649 * enum ieee80211_smps_mode - spatial multiplexing power save mode
1676 * in power saving. Power saving will not be enabled until a beacon
1682 * @power_level: requested transmit power (in dBm), backward compatibility
1795 * @ps: power-save mode (STA only). This flag is NOT affected by
2206 * @power: indicates the tx power, in dBm, to be used when sending data frames
2208 * @type: In particular if TPC %type is NL80211_TX_POWER_LIMITED then tx power
2210 * %type is NL80211_TX_POWER_AUTOMATIC then it indicates default tx power.
2215 s16 power;
2270 * @txpwr: the station tx power configuration
2402 * indicates if an associated station made a power state transition.
2472 * for power saving stations in the hardware/firmware and others
2475 * multicast frames when there are power saving stations so that
2496 * Hardware has power save support (i.e. can go to sleep).
2867 * @tx_power_levels: a list of power levels supported by the wifi hardware.
2868 * The power levels can be specified either as integer or fractions.
2869 * The power level at idx 0 shall be the maximum positive power level.
3142 * there's data traffic and still saving significantly power in idle
3171 * which will reduce system power consumption. It usually works so that
3180 * whenever power save is enabled, that is %IEEE80211_CONF_PS is set. When
3181 * power save is enabled, the stack will not check for beacon loss and the
3229 * DOC: Spatial multiplexing power save
3231 * SMPS (Spatial multiplexing power save) is a mechanism to conserve
3232 * power in an 802.11n implementation. For details on the mechanism
3234 * "11.2.3 SM power save".
3258 * in monitor mode. However, for best CPU usage and power consumption,
3451 * but this has negative impact on power consumption.
3796 * that power save is disabled.
3884 * @sta_notify: Notifies low level driver about power state transition of an
3889 * @sta_set_txpwr: Configure the station tx power. This callback set the tx
3890 * power for the station.
4021 * queues before entering power save.
4177 * @get_txpower: get current maximum tx power (in dBm) based on configuration
4233 * @set_sar_specs: Update the SAR (TX power) settings.
5655 * frames when power saving is used, 802.11 code buffers them in the host
6282 * will be sent despite the station being in power-save.