Lines Matching refs:name
106 printk("%s: scb_cmd timed out: %04x,%04x .. disabling i82586!!\n",dev->name,p->scb->cmd_cuc,p->scb->cus); \
114 printk("%s: scb_cmd (ruc) timed out: %04x,%04x .. disabling i82586!!\n",dev->name,p->scb->cmd_ruc,p->scb->rus); \
194 ret = request_irq(dev->irq, sun3_82586_interrupt,0,dev->name,dev);
274 printk("%s: Init-Problems (alloc).\n",dev->name);
351 printk("%s: SUN3 Intel 82586 found at %lx, ",dev->name,dev->base_addr);
362 printk("\n%s: Illegal memory size %d. Allowed is 0x2000 or 0x4000 or 0x8000 bytes.\n",dev->name,size);
432 printk("%s: switching to promisc. mode\n",dev->name);
450 printk("%s: configure command failed: %x\n",dev->name,swab16(cfg_cmd->cmd_status));
474 printk("%s (82586): individual address setup command failed: %04x\n",dev->name,swab16(ias_cmd->cmd_status));
497 printk("%s: Problems while running the TDR.\n",dev->name);
510 printk("%s: TDR: Transceiver problem. Check the cable(s)!\n",dev->name);
512 printk("%s: TDR: No correct termination %d clocks away.\n",dev->name,result & TDR_TIMEMASK);
516 printk("%s: TDR: Detected a short circuit %d clocks away.\n",dev->name,result & TDR_TIMEMASK);
519 printk("%s: TDR: Unknown status %04x\n",dev->name,result);
545 printk("%s: Can't apply multicast-address-list.\n",dev->name);
586 printk("%s: not enough shared-mem for your configuration!\n",dev->name);
720 printk("%s: Receiver-Unit went 'NOT READY': %04x/%02x.\n",dev->name,(int) stat,(int) p->scb->rus);
732 printk("%s: oops! CU has left active state. stat: %04x/%02x.\n",dev->name,(int) stat,(int) p->scb->cus);
742 printk("%s: Acknowledge timed out.\n",dev->name);
801 printk("%s: Whoops .. no end mark in RBD list\n",dev->name);
809 printk("%s: received oversized frame! length: %d\n",dev->name,totlen);
815 printk("%s: oops! rfd-error-status: %04x\n",dev->name,status);
847 printk("%s: RU hasn't fetched next RFD (not busy/complete)\n",dev->name);
858 printk("%s: received a FC intr. without having a frame: %04x %d\n",dev->name,status,old_at_least);
894 printk("%s: Receive-Unit restarted. Status: %04x\n",dev->name,p->scb->rus);
912 printk("%s: strange .. xmit-int without a 'COMPLETE'\n",dev->name);
923 printk("%s: late collision detected.\n",dev->name);
928 printk("%s: no carrier detected.\n",dev->name);
931 printk("%s: loss of CTS detected.\n",dev->name);
934 printk("%s: DMA underrun detected.\n",dev->name);
937 printk("%s: Max. collisions exceeded.\n",dev->name);
973 printk("%s: strange ... timeout with CU active?!?\n",dev->name);
974 printk("%s: X0: %04x N0: %04x N1: %04x %d\n",dev->name,(int)swab16(p->xmit_cmds[0]->cmd_status),(int)swab16(p->nop_cmds[0]->cmd_status),(int)swab16(p->nop_cmds[1]->cmd_status),(int)p->nop_point);
989 printk("%s: xmitter timed out, try to restart! stat: %02x\n",dev->name,p->scb->cus);
990 printk("%s: command-stats: %04x %04x\n",dev->name,swab16(p->xmit_cmds[0]->cmd_status),swab16(p->xmit_cmds[1]->cmd_status));
991 printk("%s: check, whether you set the right interrupt number!\n",dev->name);
1014 printk("%s: Sorry, max. framelength is %d bytes. The length of your frame is %d bytes.\n",dev->name,XMIT_BUFF_SIZE,skb->len);
1022 printk("%s: Queue was locked\n",dev->name);
1042 printk("%s: Hmmm .. CU is still running and we wanna send a new packet.\n",dev->name);
1043 printk("%s: stat: %04x %04x\n",dev->name,p->scb->cus,swab16(p->xmit_cmds[0]->cmd_status));
1069 printk("%s: Can't start transmit-command.\n",dev->name);
1177 printk("%s: Can't get dump information.\n",dev->name);