Lines Matching defs:port
71 * 0x33-0x3a CSI-2 TX (per-port paged on DS90UB960, shared on 954) (UB960_TR)
73 * 0x4d-0x7f FPD-Link RX, per-port paged (UB960_RR)
75 * 0xd0-0xdf FPD-Link RX, per-port paged (UB960_RR)
82 * UB960_RR_* = FPD-Link RX, per-port paged register
83 * UB960_TR_* = CSI-2 TX, per-port paged register
430 u8 nport; /* RX port number, and index in priv->rxport[] */
486 u8 nport; /* TX port number, and index in priv->txport[] */
815 dev_err(dev, "%s: cannot select tx port %d (%d)!\n", __func__,
1412 /* The rest are port specific */
1655 ser_pdata->port = nport;
1894 /* Enable all interrupt sources from this port */
1910 /* Enable RX port */
1974 /* RX port to half-rate */
2068 /* RX port to 7.55G mode */
2111 /* Enable all interrupt sources from this port */
2124 /* Enable RX port */
2278 * from a one RX port will be mapped to the same VC. Also, the hardware
2279 * dictates that all streams from an RX port must go to a single TX port.
2281 * This function decides the target VC numbers for each RX port with a simple
2282 * algorithm, so that for each TX port, we get VC numbers starting from 0,
2286 * first TX port and the secont two go to the second TX port, we would get
2318 dev_dbg(dev, "enable TX port %u\n", nport);
2329 dev_dbg(dev, "disable TX port %u\n", nport);
2339 dev_dbg(dev, "enable RX port %u\n", nport);
2350 dev_dbg(dev, "disable RX port %u\n", nport);
2482 * Keep all port forwardings disabled by default. Forwarding will be
2514 /* Map all VCs from this port to the same VC */
2523 /* Map all VCs from this port to VC(nport) */
2575 /* Enable TX port if not yet enabled */
2602 /* Enable the RX port if not yet enabled */
2613 dev_dbg(dev, "enable RX port %u streams %#llx\n", nport,
2640 dev_dbg(dev, "disable RX port %u streams %#llx\n", nport,
2652 /* Disable RX port if no active streams */
2696 dev_dbg(dev, "disable RX port %u streams %#llx\n", nport,
2708 /* Disable RX port if no active streams */
2713 /* Disable TX port if no active streams */
3486 dev_err(dev, "rx%u: failed to parse RX port\n", nport);
3508 unsigned int port = nport + priv->hw_data->num_rxports;
3512 port, 0, 0);
3740 * We do locking in the driver to cover the TX/RX port selection and the
3958 * Clear any errors caused by switching the RX port settings while