Lines Matching refs:device
70 /* Generic Bluetooth USB device */
73 /* Generic Bluetooth AMP device */
438 /* Asus WL-BTD202 device */
738 /* Dell OptiPlex 3060 (QCA ROME device 0cf3:e007) */
745 /* Dell XPS 9360 (QCA ROME device 0cf3:e300) */
752 /* Dell Inspiron 5565 (QCA ROME device 0cf3:e009) */
868 /* This is not an unbalanced PM reference since the device will reset */
875 bt_dev_err(hdev, "Resetting usb device.");
910 * is going to yank the device off the USB and then replug. So doing
912 * (standard USB disconnect), and the new device is detected cleanly
978 /* Toggle the hard reset line. The Realtek device is going to
981 * device is detected cleanly and bound to the driver again like
989 bt_dev_err(hdev, "Reset Realtek device via gpio");
1021 bt_dev_err(hdev, "Reset qca device via bt_en gpio");
1023 /* Toggle the hard reset line. The qca bt device is going to
1026 * device is detected cleanly and bound to the driver again like
1321 * -ENODEV: device got disconnected
1437 * -ENODEV: device got disconnected
1533 * -ENODEV: device got disconnected
1689 * -ENODEV: device got disconnected
2345 * squatting of this poor old Bluetooth 1.1 device. Even sold as such.
2406 * early Bluetooth 1.1 device from CSR.
2420 * the device was suspended at least once (yes, really).
2443 bt_dev_warn(hdev, "CSR: Couldn't suspend the device for our Barrot 8041a02 receive-issue workaround");
2489 /* When the device is in bootloader mode, then it can send
2673 * between the two consecutive control URBs to relax the target device
2675 * the device successfully.
2684 * -ENODEV: device got disconnected
3056 bt_dev_err(hdev, "Can't get device id, subsys reset fail.");
3085 bt_dev_err(hdev, "Failed to get device id (%d)", err);
3092 bt_dev_err(hdev, "Failed to get device id (%d)", err);
3180 /* Setup a firmware which the device definitely requires */
3250 /* Disable the device */
3272 case 0xfc6f: /* Firmware dump from device */
3273 /* When the firmware hangs, the device can no longer
3299 /* Configure an out-of-band gpio as wake-up pin, if specified in device tree */
3304 struct device *dev = &data->udev->dev;
3356 bt_dev_err(hdev, "changing Marvell device address failed (%ld)",
4079 struct device *dev = &data->udev->dev;
4285 /* Allocate extra space for Intel device */
4292 /* Allocate extra space for Realtek device */
4297 /* Allocate extra space for Mediatek device */
4768 static void btusb_coredump(struct device *dev)