Lines Matching defs:mode
39 u32 mode;
108 bt_dev_err(hdev, "Entering manufacturer mode failed (%ld)",
124 * 0x00: Just disable the manufacturing mode (0x00).
125 * 0x01: Disable manufacturing mode and reset with patches deactivated.
126 * 0x02: Disable manufacturing mode and reset with patches activated.
133 bt_dev_err(hdev, "Exiting manufacturer mode failed (%ld)",
202 bt_dev_err(hdev, "Changing Intel diagnostic mode failed (%d)",
235 /* Legacy ROM device needs to be in the manufacturer mode to apply
687 __u8 mode;
712 cp.mode = IBT_REG_MODE_8BIT;
715 cp.mode = IBT_REG_MODE_16BIT;
718 cp.mode = IBT_REG_MODE_32BIT;
770 u8 mode;
778 mode = IBT_REG_MODE_8BIT;
781 mode = IBT_REG_MODE_16BIT;
784 mode = IBT_REG_MODE_32BIT;
796 cp->mode = mode;
1124 * mode or is running operational firmware. The value 0x06 identifies
1163 * mode or is running operational firmware. The value 0x01 identifies
1277 * lines for 2ms when it receives Intel Reset in bootloader mode.
1368 ppag->mode = (u32)p->package.elements[1].integer.value;
1621 * disable the manufacturer mode, for example patch activation
1728 /* Enable the manufacturer mode of the controller.
1729 * Only while this mode is enabled, the driver can download the
1751 * the manufacturer mode is disabled with reset and activating the
1754 * If the firmware patching fails, the manufacturer mode is
1774 /* Patching completed successfully and disable the manufacturer mode
1794 /* Disable the manufacturer mode without reset */
1806 /* Patching failed. Disable the manufacturer mode with reset and
1967 * mode or is running operational firmware. The value 0x06 identifies
1977 * case since that command is only available in bootloader mode.
2098 /* Before switching the device into operational mode and with that
2157 /* Once the device is running in operational mode, it needs to
2216 * mode or is running operational firmware. The value 0x03 identifies
2226 * case since that command is only available in bootloader mode.
2233 * Check for valid bd address in boot loader mode. Device
2290 /* Before switching the device into operational mode and with that
2443 /* PPAG mode
2449 if ((ppag.mode & 0x01) != BIT(0) && (ppag.mode & 0x02) != BIT(1)) {
2450 bt_dev_dbg(hdev, "PPAG-BT: EU, China mode are disabled in CB/BIOS");
2454 ppag_cmd.ppag_enable_flags = cpu_to_le32(ppag.mode);
2461 bt_dev_info(hdev, "PPAG-BT: Enabled (Mode %d)", ppag.mode);
2608 /* Once the device is running in operational mode, it needs to
2809 * to bootloader mode and are not populated in operational mode