Lines Matching defs:bytes
722 * SK, ASC, and ASCQ bytes for later use in fixed or descriptor
907 * Fill in Extend bit, and the high order bytes
2017 rbuf[3] = num - 4; /* page len (assume less than 256 bytes) */
2234 * using the t2cdlunits 0xa (10ms). Since the SCSI duration limits are 2-bytes
2256 * Fill the subpage. The first four bytes of the T2A/T2B mode pages
2310 * The first four bytes of ATA Feature Control mode page are a header.
2395 0, 0x2, 0x0 /* block length: 512 bytes */
2518 u32 sector_size; /* physical sector size in bytes */
2592 rbuf[3] = 8; /* just one lun, LUN 0, size 8 bytes */
2707 * bytes to transfer is 2n+1. According to the spec, what
2709 * transferred and transfer 2n+2 bytes where the last byte is
2713 * indicate and transfer 2n bytes and then indicate and
2714 * transfer 2 bytes where the last byte is padding.
2718 * These controllers use actual number of transferred bytes to
2719 * update DMA pointer and transfer of 4n+2 bytes make those
2720 * controller push DMA pointer by 4n+4 bytes because SATA data
2721 * FISes are aligned to 4 bytes. This causes data corruption
3142 * @trmax: Maximum number of entries that will fit in sector_size bytes.
3158 * Return: Number of bytes copied into sglist.
3259 * size must match sector size in bytes
3415 unsigned int bytes = 0;
3424 if (bytes == 0) {
3441 bytes += 64;
3464 bytes += 64;
3638 * @len: number of valid bytes in the input buffer
3656 * The first two bytes of def_cache_mpage are a header, so offsets
3700 * The first two bytes of def_control_mpage are a header, so offsets
3743 * The first four bytes of ATA Feature Control mode page are a header,
3787 * @len: number of valid bytes in the input buffer