Lines Matching defs:power
302 * @BSS_CHANGED_TXPOWER: TX power setting changed for this interface
590 * @ps: power-save mode (STA only). This flag is NOT affected by
595 * @txpower: TX power in dBm. INT_MIN means not configured.
596 * @txpower_type: TX power adjustment used to control per packet Transmit
1440 * Must be a power of two, and be set to at least 1!
1473 * @IEEE80211_CONF_PS: Enable 802.11 power save mode (managed mode only).
1474 * This is the power save mode defined by IEEE 802.11-2007 section 11.2,
1502 * @IEEE80211_CONF_CHANGE_POWER: the TX power changed
1522 * enum ieee80211_smps_mode - spatial multiplexing power save mode
1549 * in power saving. Power saving will not be enabled until a beacon
1555 * @power_level: requested transmit power (in dBm), backward compatibility
2009 * @power: indicates the tx power, in dBm, to be used when sending data frames
2011 * @type: In particular if TPC %type is NL80211_TX_POWER_LIMITED then tx power
2013 * %type is NL80211_TX_POWER_AUTOMATIC then it indicates default tx power.
2018 s16 power;
2067 * @txpwr: the station tx power configuration
2123 * indicates if an associated station made a power state transition.
2193 * for power saving stations in the hardware/firmware and others
2196 * multicast frames when there are power saving stations so that
2217 * Hardware has power save support (i.e. can go to sleep).
2841 * there's data traffic and still saving significantly power in idle
2870 * which will reduce system power consumption. It usually works so that
2879 * whenever power save is enabled, that is %IEEE80211_CONF_PS is set. When
2880 * power save is enabled, the stack will not check for beacon loss and the
2928 * DOC: Spatial multiplexing power save
2930 * SMPS (Spatial multiplexing power save) is a mechanism to conserve
2931 * power in an 802.11n implementation. For details on the mechanism
2933 * "11.2.3 SM power save".
2957 * in monitor mode. However, for best CPU usage and power consumption,
3150 * but this has negative impact on power consumption.
3464 * that power save is disabled.
3539 * @sta_notify: Notifies low level driver about power state transition of an
3544 * @sta_set_txpwr: Configure the station tx power. This callback set the tx
3545 * power for the station.
3672 * queues before entering power save.
3824 * @get_txpower: get current maximum tx power (in dBm) based on configuration
5133 * frames when power saving is used, 802.11 code buffers them in the host
5710 * will be sent despite the station being in power-save.