Lines Matching defs:power
153 * @max_power: maximum transmission power (in dBm)
154 * @max_reg_power: maximum regulatory transmission power (in dBm)
273 * @non_srg_max_offset: non-SRG maximum tx power offset
274 * @min_offset: minimal tx power offset an associated station shall use
275 * @max_offset: maximum tx power offset an associated station shall use
589 * design (e.g. by antennas or external power amplifier).
896 * ieee80211_chandef_max_power - maximum transmission power for the chandef
898 * In some regulations, the transmit power may depend on the configured channel
904 * Returns: maximum allowed transmission power in dBm for the chandef
1292 * @power: tx power (in dBm) to be used for sending data traffic. If tx power
1293 * is not provided, the default per-interface tx power setting will be
1294 * overriding. Driver should be picking up the lowest tx power, either tx
1295 * power per-interface or per-station.
1296 * @type: In particular if TPC %type is NL80211_TX_POWER_LIMITED then tx power
1298 * %type is NL80211_TX_POWER_AUTOMATIC then it indicates default tx power.
1303 s16 power;
1335 * @local_pm: local link-specific mesh power save mode (no change when set
1350 * @txpwr: transmit power for an associated station
1648 * @local_pm: local mesh STA power save mode
1649 * @peer_pm: peer mesh STA power save mode
1650 * @nonpeer_pm: non-peer mesh STA power save mode
1936 * @power_mode: The default mesh power save mode which will be the initial
3734 * @set_tx_power: set the transmit power according to the parameters,
3735 * the power passed is in mBm, to get dBm use MBM_TO_DBM(). The
3736 * wdev may be %NULL if power was set for the wiphy, and will
3737 * always be %NULL unless the driver supports per-vif TX power
3739 * @get_tx_power: store the current TX power into the dbm variable;
3776 * @set_power_mgmt: Configure WLAN power management. A timeout value of -1