Lines Matching refs:xhci_dbg
486 xhci_dbg(xhci, "Ignoring request to disable "
492 xhci_dbg(xhci,
500 xhci_dbg(xhci, "disable port %d-%d, portsc: 0x%x\n",
551 xhci_dbg(xhci, "clear port%d %s change, portsc: 0x%x\n",
581 xhci_dbg(xhci, "set port power %d-%d %s, portsc: 0x%x\n",
627 xhci_dbg(xhci, "Disable all slots\n");
641 xhci_dbg(xhci, "Disable all port (PP = 0)\n");
649 xhci_dbg(xhci, "Stop controller\n");
657 xhci_dbg(xhci, "Enter Test Mode: %d, Port_id=%d\n",
694 xhci_dbg(xhci, "Set port %d-%d link state, portsc: 0x%x, write 0x%x",
865 xhci_dbg(xhci, "resume USB2 port %d-%d\n",
887 xhci_dbg(xhci, "slot_id is zero\n");
1131 xhci_dbg(xhci, "Wrong hub descriptor type for "
1166 xhci_dbg(xhci, "Get port status %d-%d read: 0x%x, return 0x%x",
1254 xhci_dbg(xhci, "Disable port %d-%d\n",
1271 xhci_dbg(xhci, "Enable port %d-%d\n",
1294 xhci_dbg(xhci, "CTC flag is 0, port already supports entering compliance mode\n");
1303 xhci_dbg(xhci, "Enable compliance mode transition for port %d-%d\n",
1352 xhci_dbg(xhci, "missing U0 port change event for port %d-%d\n",
1398 xhci_dbg(xhci, "set port reset, actual port %d-%d status = 0x%x\n",
1404 xhci_dbg(xhci, "set port remote wake mask, actual port %d-%d status = 0x%x\n",
1462 xhci_dbg(xhci, "clear USB_PORT_FEAT_SUSPEND\n");
1463 xhci_dbg(xhci, "PORTSC %04x\n", temp);
1485 xhci_dbg(xhci, "slot_id is zero\n");
1600 xhci_dbg(xhci, "%s: stopping port polling.\n", __func__);
1632 xhci_dbg(xhci, "suspend failed because a port is resuming\n");
1659 xhci_dbg(xhci, "port %d-%d polling in bus suspend, waiting\n",
1667 xhci_dbg(xhci, "Bus suspend bailout, port over-current detected\n");
1675 xhci_dbg(xhci, "Bus suspend bailout, port connect change\n");
1678 xhci_dbg(xhci, "port %d-%d not suspended\n",
1813 xhci_dbg(xhci, "reset stuck port %d-%d\n",