Lines Matching defs:transfer
47 MODULE_PARM_DESC(trans_mode, "transfer mode (0: BIOS(default) 1: Async 2: Ultra20M");
528 /* transfer control */
546 * For bus master transfer, it's taken off.
555 * transfer parameter to ASIC
846 * nsp32_setup_sg_table - build scatter gather list for transfer data
849 * Note: NinjaSCSI-32Bi/UDE bus master can not transfer over 64KB at a time.
879 "can't transfer over 64KB at a time, size=0x%lx", le32_to_cpu(sgt[i].len));
970 * If target is the first time to transfer after the reset
972 * message SDTR is needed to do synchronous transfer.
1076 nsp32_dbg(NSP32_DEBUG_INIT, "unknown transfer mode");
1100 * appropriate value before restarting bus master transfer.
1408 * transfer reliability when BMCNTERR is occurred in
1493 seq_printf(m, " transfer %d.%dMB/s, offset %d",
1859 unsigned short transfer = 0;
1891 transfer = 0;
1892 transfer |= (TRANSFER_GO | ALL_COUNTER_CLR);
1895 transfer |= BM_START;
1898 transfer |= CB_MMIO_MODE;
1900 transfer |= CB_IO_MODE;
1902 nsp32_write2(base, TRANSFER_CONTROL, transfer);
2041 * failed. Fall back to async transfer mode, and set
2264 * to fall back into asynchronous transfer mode.
2341 nsp32_set_async(data, target); /* set as ASYNC transfer mode */
2384 * target <-> initiator use ASYNC transfer
2401 * target <-> initiator use maximum SYNC transfer
2584 * Bus master transfer mode is supported currently.
2708 * ready to start synchronous transfer without any preparation,
2709 * but we are difficult to control transfer speed. In addition,
2710 * it prevents device transfer speed from effecting EEPROM start-up
2717 * device transfer mode.
2846 * stop all transfer
2855 * fall back to asynchronous transfer mode
3001 * same or lower than 3, then transfer speed is set as ULTRA-20M.
3003 * than 4, then transfer speed is set as FAST-10M.
3006 * only ignored. If auto_sync is 0 (auto), then transfer speed is