Lines Matching defs:data
205 /* command or response/notification data follows immediately */
206 u8 data[];
262 * 5: Value of 0x20 in bits 7:0 indicates 6 Mbps HT40 duplicate data
303 /* Bit 12: (1) Duplicate data on both 20MHz chnls. HT40 (bit 11) must be set. */
394 * For 4965, this notification contains important calibration data for
442 * data SRAM (access via HBUS_TARG_MEM_* regs) that are useful for debugging:
458 * __le32 data; event_id-specific data value
460 * Entries without timestamps contain only event_id and data.
474 * __le32 data1; error-specific data
475 * __le32 data2; error-specific data
619 /* accept all data frames */
945 * their own txpower/rate setup data).
1191 * It is provided only for calculating minimum data set size.
1203 /* Fixed (non-configurable) rx data from phy */
1222 u8 non_cfg_phy_cnt; /* non configurable DSP phy data byte count */
1223 u8 cfg_phy_cnt; /* configurable DSP phy data byte count */
1224 u8 stat_id; /* configurable DSP phy data set ID */
1250 * from which data will be transmitted.
1258 * This includes trying lower data rates than the one requested in the Tx
1312 * Set this for management frames, non-QOS data frames, non-unicast frames,
1326 * alignment of frame's payload data field.
1329 * field (but not both). Driver must align frame data (i.e. data following
1409 * length is 26 or 30 bytes, followed by payload data
1476 * data frames, this field may be used to selectively reduce initial
1511 * length is 26 or 30 bytes, followed by payload data
1925 * Each history set contains, separately for each possible rate, data for a
1926 * sliding win of the 62 most recent tx attempts at that rate. The data
2523 u8 data[];
2567 u8 data[];
2834 __le32 interference_data_flag; /* flag for interference data
2835 * availability. 1 when data is